TO PLACE AN ORDER
Please Call
1-800-794-5586
Home
About Us
Contact Us
Our Rubber Product Line
Rubber Letters
   How To

  
Pricing

Rubber Numbers
   How To
   Pricing

Concrete Address Blocks

Rubber Military Art

Rubber Art
   Borders
 
 Arrows

Rubber Sports Art
   Templates
   Team Mascots

   Ball, Bats, Etc.

Rubber Silhouettes
   Dogs
   Cats

Custom Molds
  
How To Order

Gallery

Verses for Pet Memorials

                                      

 

Military Rubber Templates
For Stepping Stones

US Air Force Logo
11" - $65.00   15" - $79.00

US Army Logo
11" - $65.00   15" - $79.00

US Coast Guard
11" - $65.00   15" - $79.00

US Marine Corps Logo
11" - $65.00   15" - $79.00

US Navy Logo
11" - $65.00   15" - $79.00

Boy Scouts Of America Logo
11" - $65.00   15" - $79.00

Here's How To Do It               (CLICK PHOTOS TO ENLARGE)  

                
1.    
Begin by spraying a light amount of mold release into your mold.
 

                 
2.     Next brush on a very light coat of
petroleum jelly onto the face of your
rubber art.  Then using a dry brush, remove excess vaseline leaving only a very light film.    PLACE THE RUBBER INTO YOUR PLASTIC MOLD.

                  
3.     An extremely important  step is next.  Using a hand spray bottle filled with water and about 20 drops of liquid soap, spray a light water mist over your entire rubber art.  This helps to eliminate bubbles in your casting by allowing the bubble to float away from the rubber art as you pour the concrete.

                  
4.     Your mold is now ready to pour the concrete.  For stepping stones and other small castings, use 1 part concrete and 3 parts sand.  Do not use stones or ready mixes.  Concrete mix should be very fluid when pouring.
 

                 
5.     Pour your concrete mix. 
The concrete should flow over the mold, not dumped.

                
6.     When your ready for demolding (usually overnight is enough), grab the rubber and slowly remove it from the stone.  It is not necessary to be gentle with the rubber as it is very strong and will tolerate some abuse.


7.     After removing the rubber, turn the mold upside down, tap gently and remove your casting.  Please note the crisp sharpness of the details and lettering.   Then finish as desired. 

               
  YOUR FINISHED PRODUCT

TO PLACE AN ORDER
Please Call
1-800-794-5586